# Dump SPI flash via I2C (if supported) python uis_dump.py --bus 1 --addr 0x42 --output backup_fw.bin Or using SPI programmer:
// Write firmware chunk by chunk (max 64 bytes per transaction) for (int addr = 0; addr < fw_size; addr += 64) i2c_write_block(0x42, 0x80 + (addr >> 8), &fw_buf[addr], 64);
UIS8141E_fw_v3.02.bin UIS8141E_fw_v3.01_60fps.bin ⚠️ Do not mix firmware for UIS8141E (ToF) with UIS8141 (IR-only) – they are not interchangeable. Method A – Via USB (if module has onboard USB bridge) Most evaluation modules expose a USB port (FTDI or CH340). The flash is accessible over I2C via USB. uis8141e firmware
This guide covers: obtaining firmware, flashing via USB/I2C, common version types, and debugging. Firmware for the UIS8141E is typically stored in an external SPI Flash (e.g., Winbond W25X40). The module identifies itself with a specific chip_id and firmware_version .
// Exit & restart i2c_write(0x42, 0x00, 0x00); // exit update mode After power cycling: # Dump SPI flash via I2C (if supported) python uis_dump
# 1. Connect module USB -> PC # 2. Identify I2C bus (usually 1 or 2) i2cdetect -y 1 # Should show device at 0x42 (UIS8141E I2C address) python flash_uis8141e.py --bus 1 --addr 0x42 --fw uis8141e_fw_v3.02.bin
# Re-read firmware version v4l2-ctl -d /dev/video0 --get-ctrl=firmware_version v4l2-ctl -d /dev/video0 --stream-mmap --stream-count=100 --stream-to=/tmp/depth.raw This guide covers: obtaining firmware, flashing via USB/I2C,
If version matches expected and no CRC errors appear in dmesg , flash is successful. | Symptom | Likely Cause | Solution | |---------|--------------|----------| | No /dev/video* | Wrong firmware for USB PID/VID | Reflash matching USB descriptor firmware | | Depth values all zero | Firmware missing calibration | Upload factory calibration (separate .cal file) | | Sensor resets repeatedly | SPI flash corruption | Erase flash, reflash, verify checksum | | I2C error after update | Bootloader stuck | Pull BOOT pin low for 2s during power-on | 7. Backup Current Firmware Before updating, always back up the existing firmware:
# If using V4L2 driver (UIS8141E appears as /dev/videoX) v4l2-ctl -d /dev/video0 --get-ctrl=firmware_version
// Example I2C sequence (C pseudo-code) uint8_t fw_buf[128*1024]; FILE *fp = fopen("uis8141e_fw.bin", "rb"); fread(fw_buf, 1, sizeof(fw_buf), fp); // Enter firmware update mode i2c_write(0x42, 0x00, 0xA5); // unlock i2c_write(0x42, 0x01, 0x5A); // enter bootloader
Erasing SPI flash... OK Writing firmware (128 KB)... OK Verifying checksum... OK Rebooting device... If you have direct access to the UIS8141E (not a module), use an ST-Link or J-Link to program the external SPI flash.