Pon-6 — Pre Oiler

After a year and a half, the PON-6 has been flawless. The pump still sounds healthy, no solenoid sticking, no leaks at the sandwich plate. My truck has 210,000 miles and uses less than half a quart of oil between changes—down from nearly a full quart before. Cold starts in 10°F weather are no longer anxiety-inducing. The only minor annoyance: The pre-lube cycle adds about 8 seconds to your “startup routine,” so you can’t just jump in, crank, and go. You learn to turn the key, then buckle your seatbelt.

Out of the box, the PON-6 feels industrial, not consumer-grade. It’s a compact, brushed aluminum unit weighing about 3.5 lbs. The solenoids are robust, the wiring harness uses automotive-grade, heat-resistant sheathing, and the included steel braided lines inspire confidence. This is not a cheap plastic gizmo; it’s built for the long haul. The kit came with a 3-pin weather-sealed connector, a momentary push-button switch, and surprisingly clear, if slightly technical, instructions. pon-6 pre oiler

The PON-6 taps into your engine’s oil galley (usually via a sandwich plate at the oil filter or a dedicated port). It contains a small electric pump and a reservoir that stores a charge of pressurized oil. When you turn your ignition to the "ON" position (or hit a manual button), it pre-lubricates all bearings, lifters, and turbo journals with oil at around 15-20 PSI. Only after that cycle (typically 6-10 seconds) does it allow you to crank the starter. On shutdown, it can also post-lube your turbo, preventing coking. After a year and a half, the PON-6 has been flawless