New- Hints | And Kinks For The Radio Amateur

Not always, but in a pinch, stranded 18-gauge wire soaked in flux outperforms no wick at all. Keep a 6" piece pre-fluxed in a tiny ziplock bag in your go-kit. 3. The "Eyeglass" SMA Wrench (Free & Perfect) The problem: SMA connectors need to be finger tight plus 1/8 turn . Overtighten, and you’ll snap the center pin or ruin the female receptacle (especially on cheap HTs or SDR dongles).

By WB2FAS (In the spirit of the original QST column)

Use rare earth magnets (neodymium, 1/2" diameter or larger) with a screw hole in the center. Screw a copper ground lug directly to the magnet. Stick the magnet to the metal desk. Connect all your gear grounds to that lug via short straps. New- Hints and Kinks for the Radio Amateur

73, and may your SWR be low and your soldering iron hot. Do you have a kink to share? Send it to your club newsletter or post it on QRZ—that’s how our tradition stays alive.

Tighten until it stops with light finger force, then use the screwdriver for no more than 10 degrees of additional rotation. 4. Cheap Coax Seal That Doesn’t Turn to Gum The problem: High-end coax sealing tape (Coax-Seal, etc.) works great, but it’s expensive and gets sticky-messy in heat. Not always, but in a pinch, stranded 18-gauge

Use a second mat as a soldering iron rest when traveling. The iron tip won’t burn it, and it won’t slide off the table. A Final Word The best kink is the one you discover yourself. Keep a small notebook in your shack (or a digital note) and write down every “that worked well” or “that was stupid, don’t do it again.”

Remove the knob. Drip 2–3 drops of isopropyl alcohol (91% or higher) into the shaft opening. Rotate the pot back and forth fully 20–30 times. Let it dry 5 minutes. Then add one tiny drop of lightweight machine oil (sewing machine oil or even 3-in-1) to the same spot. Rotate again 10 times. The "Eyeglass" SMA Wrench (Free & Perfect) The

WD-40 leaves a residue that attracts dust. This alcohol+oil method flushes oxidation then leaves a clean, thin lubricant film. 7. The "No-Drill" Ground Bus for a Metal Desk The problem: Your station ground needs a common bus bar, but you don’t want to drill into your nice metal desk or filing cabinet.

Zero adhesive residue. Removes cleanly. UV and weatherproof for years. Temperature range: -60°F to +500°F. One roll seals dozens of connectors. Use it over electrical tape, not under. 5. The Ruler-on-the-Mast Trick (Antenna Matching) The problem: You’re tuning a 1/4-wave ground plane or a J-pole. You slide the radiator up and down, mark it with a Sharpie, lower the mast, adjust, raise again… repeat.

The tape fills the air gap and provides friction. The bead stays exactly where you put it—even on vertical runs—and the improved surface contact actually increases common-mode impedance. 2. Instant Solder Wick (When You’re Out) The problem: You need to desolder a through-hole component. The last piece of solder wick vanished months ago.