At 2:30, Maria Chen, the shift electrician, pulled up the LogixPro simulation on her laptop—the training software she’d mastered years ago. But this wasn’t a classroom exercise. This was Exercise 2 for real.
She sprinted to the MCC (Motor Control Center) and yanked the disconnect for Titan. The massive screw element ground to a halt with a mournful groan. The plant pressure gauge needle wobbled at 92 PSI and began to fall. logixpro dual compressor exercise 2
In the LogixPro simulation, you had ladder logic timers: T4:0 for the “minimum run time” and T4:1 for the “anti-cycle delay.” Maria had no time to program. She had to become the PLC. At 2:30, Maria Chen, the shift electrician, pulled
She jumped to the control cabinet, fingers flying over the old Allen-Bradley pushbuttons. She disabled the automatic lead-lag and forced Atlas into continuous run. Then she saw the problem: Atlas’s unloader solenoid was sticky. The compressor was starting under full load, drawing 300% amperage. The thermal overload relay clicked once, twice—on the third click, it would trip. She sprinted to the MCC (Motor Control Center)